{"id":144,"date":"2021-02-12T13:55:03","date_gmt":"2021-02-12T13:55:03","guid":{"rendered":"https:\/\/shop.davega.eu\/?post_type=product&p=144"},"modified":"2026-08-04T09:53:27","modified_gmt":"2026-08-04T09:53:27","slug":"davega-x","status":"publish","type":"product","link":"https:\/\/shop.davega.eu\/?product=davega-x","title":{"rendered":"DAVEGA X, assembled"},"content":{"rendered":"

Pre-assembled and ready to use. Just plug it in.<\/p>\n

DAVEGA X is an advanced on-board telemetry device for VESC\u00ae<\/a> based speed controllers. It comes in an aluminum enclosure<\/strong> with several color options to choose from.<\/p>\n

Please see the product site<\/a> for detailed information.<\/p>\n

Package contents<\/h4>\n
    \n
  • pre-assembled DAVEGA X v1.2<\/li>\n
  • flexible ribbon cable<\/li>\n
  • JST-PH housings: 7P (2pcs), 8P (2pcs)<\/li>\n
  • screen protectors: glass (pre-installed), 2pcs acrylic (spares)<\/li>\n
  • double sided rubber tape (for replacing the screen protector)<\/li>\n
  • M3x6mm bolts: stainless steel (5pcs), blued steel (5pcs)<\/li>\n<\/ul>\n

    Note that the baseplate is no longer included and has to be ordered separately.<\/strong><\/p>\n

    What cable length do I need?<\/h4>\n

    For exact measurement, take a string and route it from the center-point of the front truck mounting holes to your ESC UART port. Then add 10 cm<\/strong> to the length.<\/p>\n

    A good quick estimate for 2WD setups with a bottom mounted enclosure is to measure the distance between the deck nose and the rear of the enclosure.<\/p>\n

    \"\"<\/p>\n

    The 100 cm cable is long enough for most setups.<\/p>\n

    7P or 8P connector?<\/h4>\n

    Find the communication port on your speed controller. The pins should be labeled as follows:<\/p>\n

      \n
    • 5V<\/li>\n
    • 3.3V or VCC<\/li>\n
    • GND<\/li>\n
    • ADC1<\/li>\n
    • RX or TX<\/li>\n
    • TX or RX<\/li>\n
    • ADC2<\/li>\n
    • ADC3 (missing on 7P ports)<\/li>\n<\/ul>\n

      The communication port on most VESC\u00ae based controllers either has 7 or 8 pins (there’s an extra ADC3 pin in the latter case). Should your communication port have a different number of pins or should the pins be organized in a different order than on the list above please let us know in the order notes and we will do our best to set up your cable as appropriate. Note that DAVEGA X is tolerant to swapping RX\/TX starting from firmware v4.04 (guaranteed on all new units).<\/p>\n

      We also highly recommend that you watch this video where we discuss the cable setup in more detail.<\/p>\n